Audeze LCD-series Pad Ring Adapter (for LCD-2/3/4/4z...etc)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows use of pads without adhesive.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 27
- Makes
- 0
- Views
- 152
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution
A simple pad adapter for the large round LCD series of headphones from Audeze. Does not work for the Maxwell or the LCD-1. Uses the original driver screw holes to mount the adapter, and requires a small change to the earpads.
The adapters were designed with multi-material printing in mind. Using PETG for the rings and PLA for the support interfaces allowed me to get very clean prints. I have included a model that has been chopped in half and can be printed on end, though I'd recommend printing with a brim.
Before mounting the both the pads and the rings, I'd recommend cleaning all of the adhesive off the drivers and the pads.
Does not change the sound. At least, according to my own listening it doesn't.
For the earpads, you'll need to move the plastic ring, with felt side towards the ear, into the ear-side cavity of the pad. It'll require significant bending of the ring (shown in pic 3), but so long as you don't crease it it'll work fine. You could probably omit the ring entirely, but I chose to keep it.
Be extra careful when unscrewing/screwing near the driver. Those magnets are insanely strong, and a screw into the driver will most likely destroy it.
I do not take responsibility if the above happens to your headphones!