Asthma Inhaler chamber
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holding chamber for Albuterol sulfate asthma inhaler (not FDA approved, but works well)
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 43
- Makes
- 0
- Views
- 255
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for folks that may have trouble with inhaler use. This device captures the inhaler “shot(s)” allowing normal inhale.
The device is a chamber with a vortex air inlet and a check valve output that permits easy inhale without wasting the dose.
It is a reproduction of many similar devices used for this purpose.
six parts are needed, 3 are printed in TPU; Cap, Receiver (two types for differing inhalers) and the check valve - 0.15 mm layer, 15% infill. 3 are in PET-G, Body, Mouth Piece, and Vortex 0.20 layer height, 15% infill with brim.
All parts are washable in hot water (NOT dishwasher safe)