Samsung Qi2 Single Mag Wireless Charger Holder

This mount slides onto a small shelving unit to hold the new Samsung Qi2 magnetic wireless charger. It has built-in cable routing to hide the charger’s wiring and route it to the rear of the unit, allowing for convenient bedside charging—or use anywhere you regularly set your phone down.

NOTE: This version fits a unit with an upright and shelf that are both 15.3 mm in width. The shelf is also set back 15 mm from the upright. The shelves are held in place by small push-in dowels on the underside of the shelf (these protrude 10 mm × 5 mm), all of which are accounted for in this model. This makes the design somewhat niche, as it only works with a unit of these specific dimensions. Feel free to modify it to suit your own setup.

Unfortunately, I had just enough woodfill PLA to print this model, and a support failed during printing—causing a layer shift just over halfway through—but it still works!