Hayward PSV Diverter Valve spacer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are the spacers modeled after the original Hayward PSV diverter valves. Some aftermarket rebuild kits are…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
These are the spacers modeled after the original Hayward PSV diverter valves. Some aftermarket rebuild kits are generic and missing the spacer that's supposed to be included for Hayward. I found this out when the ones my pool guy was using was missing this spacer when I went to install my original Hayward kit ($$$). Ideally, this spacer should be placed in between the two o-rings top of the diverter just like the original. The cheap rebuild kits for Jandy/Hayward/Pentair includes a cap o-ring and 2 smaller o-rings for the top on the diverter, add this spacer to keep the setup stock for Hayward valves.
Layer height: 0.16 or 0.08. The overall height is set to 1.6mm specifically for these layer heights Print this spacer solid, all walls or walls + 100% infill
Print in PETG since these will be installed inside of the water valve. Stock valves look like Teflon, but my recent rebuild kit was using a plastic washer like this.
Category: Outdoor & Garden