FireTV Remote Cradle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enjoy one finger button pushing on an Amazon FireTV remote rather than having to pick it up.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Though a round bottomed remote may feel comfortable in your hand, you need to pick it up to use it rather than just hitting the buttons where it sits. I like to set the remote on the arm of my chair and just push a button without picking it up.
This remote cradle is specifically for a FireTV Cube and is about 6-1/4 inch (~15.9 cm) long. I used a jark22 on Thingiverse model of one of the smaller FireTV remotes and manipulated it in Fudion360 to generate this model. (Thanks jark22.)
My trial print used PETG, but it was a bit too rigid and tight. My final print used TPU and is a tad bit looser than I would like, no changes to the model, just a change of filament material.
I found printing the cradle on its side minimized supports and generated a very clean product. I included some slicer and an actual photo during printing.
Enjoy one-finger button pushing on the FireTV remote until Amazon decides to make their remote with a flat bottom like every other remote I have.