Floating / Dynamic Center Hub Cap 60MM OD Version for Subaru Forester 2.0XT
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The only complaint is that the clips are somewhat brittle/weak under pressure, but this is fixable with plastic JB weld.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 131
- Makes
- 0
- Views
- 890
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
With the help of Chunks3D, we were able to size and modify the model to fit my car's center wheel caps. We upgraded the parts to stainless steel variants on Amazon, used 608 2RS Ball Bearings, added threadlocker to screws, and double nutted the swing with nylon locknuts. We decided to use a flat plain top so we can stick a rounded 3D logo decal for better visuals. Overall, the creator (@Bob_1978853) clearly made a good design choice compared to other variants that use fewer weights or printed weights. The only complaint is that the clips are brittle/weak under pressure when printed in PETG, but they're fixable/bondable with plastic JB Weld, which is now very strong.
For assembly of 4 floating hub caps, you need stainless steel:
- 4x 608 2RS Ball Bearings
- 20x M4 10mm Screws
- 20x or 40x M4 Nylon Locknuts
- 4x M3 14mm Screws
- 4x M3 Nuts
Optional (at your own risk):
- Medium Strength Threadlocker for 14mm screws
- Plastic JB Weld for ball bearings to stay on the print, because when you install the pressure can push out the bearing very annoying. Also, for any of the clips that break off, just in case.