Trash Bag Roll Dispenser - Standard(40ct) + Wholesale(80ct)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
40/80 count trash bag roll dispensers - any brand 40ct rolls or wholesale 80ct rolls (Kirkland/Members Mark).
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 63
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
WHY?
This is a simple and sturdy trash bag dispenser I designed for our home, under the kitchen sink.
WHAT?
There are two versions: Standard(40ct rolls) or Large(80ct rolls).
The connectors are used for either the large or standard model housing. There are also whole trays available for download.
For a version suitable for 200mmx200mm print volumes or “no-support” version..
200mm x 200mm Print Bed Models:
https://www.printables.com/model/1481892-trash-bag-roll-dispenser-low-profile-print-version
WHEN?
Large tray, about 15hrs
Standard tray, about 13hrs
HOW?
- Install using four(4) wood screws, as described below. Point the middle curved part of the hole, on the housing piece, is pointing toward the wall (as pictured)
- Grab the bag from the bottom and pull up-and-out away from the dispenser.
- These are the recommended print settings:
Note: If not specified, and aside from specific filament settings, all other settings not mentioned are the Orca Slicer defaults for a .4 nozzle Centauri Carbon. Also, pictured models are Inland PLA Basic (they source from eSun, and Polymaker for tougher filaments), and they are plenty strong enough.
Housing
Material: Any
Infill: 100%
Support: Yes, Tree
Brackets
Material: Any
Infill: 25%
Support: No
Connectors/Fasteners
Material: Any
Infill: 25%
Support: No
Non-Printable Hardware
16-20mm (¾"-1¼") Wood Screws x 4
