xpa125b - icom ic705 interface plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an interface plate to put your XPA125B on top of your Icom IC-705. added a split version of the spacer
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 248
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is an interface plate to put your XPA125B on top of your Icom IC-705 if you already have a Windcamp protective shield .
a stand in the back of the xpa125 will hold it in the same angle as the 705.
There is also a little enclosure which you can click on to the amplifier. If you like to make the bluetooth automatic band switch
it uses a D1 mini and some perf board. https://www.amazon.com/ACEIRMC-ESP-WROOM-32-Bluetooth-Development-Compatible/dp/B08PNWB81Z?sr=8-3&language=en_US
The band switch you can find here : https://github.com/jimd2002/IC-705-XPA125b-with-ESP32-INO-file/blob/main/sketch_may10c_2025.ino
It works like a charm.
added a split version of the spacer with spring clamps (don't have a better word. I bet you know it).
because of the printing direction, the load is on the layers which is sub optimal.
But the clamps don't have to bend that far.
Because I edited the original interface plate, the space between the two spacers cannot be changed. So your printer will take a -extra travel time- bit longer to print as it would when you determine the spacing between the left and the right part.
73
Wilfred, ON4NDO.