Pet Bowl Riser for 12.5cm Bowls
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A no support, two-part print designed to raise bowls with a maximum diameter of 12.5cm by 5cm.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 14
- Makes
- 0
- Views
- 58
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution
Hello!
No supports are required for this print since there are 2 pieces.
Print the disc first!
The frustum (a new word I learnt just for this write up) was printed with the top on the plate and a brim for better plate adhesion.
A pause is required after printing 9mm (or before the start of layer 46 if printing at a layer height of 0.2mm) to insert the disc. There should be enough clearance between the disc and frustum to drop into place but there shouldn't be any movement of the disc within the slot once the print is done.