Radbody Piranha body clip

The Radbody Piranha is a very nice body, but orginally came with a bodyclip made for cars with a shorter mounting position, like the Reflex RX28. It did not fit standard (Kyosho) size cars. 

I made these body clips to fit my Atomic MRV. It should likely fit other cars as well. I printed it with PLA, you might want to experiment with print direction. So far vertical printing has worked. Tested an ASA version for 1000+ laps without issues or coming loose. 

I used this together with a modified Reflex Piranha front bumper. You still need to slightly modify the rear wheel arches slighty if your wheels make contact there. I could not move the body more forward, otherwise the front body mount would get too much play. In the pictures there is NO contact with my +3 offset Xbility wheels. 

EDIT: added some additional height offsets.  0 is the same as the original body clip I made. The negative numbers raise the body in 0.5mm steps, the positive numbers LOWER the body in 0.5mm steps. 

I've also made a front bumper mount: 

 I made a V2 version which might fit some cars better. See my other makes.