Enbrighten Vibe Eternity Light Shades/Covers (can be adapted for other shapes)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
We got a set of Enbrighten Vibe Eternity LED lights that are intended to go on your eves, and shine against the house…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 62
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
We got a set of Enbrighten Vibe Eternity LED lights that are intended to go on your eves, and shine against the house for accent. The problem is, we used them on an awning support frame, so they don't shine right next to the house, and are hard to see unless it's dark outside, and even then, you can't see the colors well if you're looking at it from the side - you have to be looking up instead. I was looking online, and Enbrighten sells a twist-on plastic shade that looks like a C9 Christmas Light Bulb - but I didn't want Christmas lights (at least not right now). I made this instead - they are decorative shades that go over the LED puck and bayonet mount using the light's wires that come out of either side of the puck.
I have a bunch of these to print, so what you see in the photos shows some of the LED pucks with the new shade, and some without the shade - so you can see the difference the shade makes. It makes it a LOT easier to see colors from a side view.
Right now I'm only using the one you see in the photo, but the base could be adapted to any shape you want (so I'm including a base without the top, so you can play with it if you want) - just plop another shape on top of the base, and you are good to go. The two "tops" I include here are a straight flute shape (Top 1, which is what I printed), and a somewhat tapered flute shape (Top 2 - I printed one of these, but decided I like the straight one better).
I used clear PLA (because I had it), but it would probably last longer with PTEG. I used supports only for the bayonet mount area, and only on the surface that faces straight down. I printed this in an upside down orientation.
Category: Outdoor & Garden