TPU Cable Clips with 10x3mm Magnets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For some USB Cables
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The 3 USB cables shown are the thickest I have and their diameters vary from one to the other, between approx. 3.4mm and 4.2mm. I made 2 stl files with slightly different dimension where one or the other flexed and grabbed on to the cable…..and they work pretty good. It was just trial and error.
After trying different settings with the TPU 95A, I used 5% Rectilinear Infill, 1 Perimeter, and 0.10 Detail Layer Height for best results. The 10x3 magnet should fit in snug but a drop of glue may be needed.
I tried using PLA but there was no flex and the edges were quite sharp around the cable but you might get it to work.