Stew675's QIDI Plus 4 Riser with added venting!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Stu's model with back venting and no need to remove the glass to move the dampers
- Rating
- 4.5 / 5
- Likes
- 23
- Downloads
- 288
- Makes
- 2
- Views
- 922
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed using eSUN PETG +HS, .2 layer height, four walls and three top and bottom layers for the base and two walls and two top and bottom layers for the dampers (BTW PETG without addatives is the bane of humanity).
I screwed up the design, so you will have to print two of each side of the dampers, since I was a bonehead and didn't center the handle during my design.
I have attached an image from Fluidd, taken just before the print ended, showing the temperatures after 4 hours of printing with dampers open and the door closed. The temperature rose slowly for the first few hours and stabilized at 35 degrees, which, as far as I have read, is ok for PLA with respect to heat creep (I was actually printing the dampers for this project).
You'll notice the orange hot-end fan duct… also shout-out to Stew for that design!