1 / 2
Ikea Luroy (LURÖY) Spacer Block / Slat joiner — image 1
1 / 2

Ikea Luroy (LURÖY) Spacer Block / Slat joiner

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple clip which fiction fits between LURÖY slats for double and queen beds to help keep the slats from falling off.

Rating
0 / 5
Likes
11
Downloads
51
Makes
0
Views
261
Reviews
0

Updated at source:

Model information

Category
Bedroom
License
Creative Commons — Attribution — Noncommercial

This Ikea Luroy clip has been designed from the ground up with 3D printing in mind. 

A single piece clip and spacer. Based off measurements of my Luroy slats as sold by Ikea in Australia. 

These slats were 50mm wide, 12mm deep.

Printing and Assembly

The holder shown in photos was printed at 0.2mm layer heights using a 0.4mm Nozzle. It should print well with larger nozzles, although the crisp edges may become more rounded. 

No brims should be required, printing fast should also work well to save time! 

The clips are snug on my slats, some needing a bit of a bump to snap in. 

I printed with 10% adaptive cubic infill and had great results. There is no requirement for supports, and the best orientation will be with the flat bottom down. 

Required Parts

No additional parts are required for this project.  

Tags