Waterpik toothbrush heads stand (different sizes)

As the Waterpik set did not contained a stand for the toothbrush heads, I designed one. And as the coding color choice is very limited (and cannot be changed), I added a magnetic space beside every emplacement to individually mark every brush with a figurine of choice :-)

I created different sizes (for 6, 5, 4, 3, and 2 toothbrush heads).

Magnets (d6 x 2mm) are embedded, you need to add a pause in the slicer to allow to insert them (see attached screenshot). I could easily create versions for other magnet sizes, just leave a comment.

For marking figurines you may choose any 3D model, scale it to fit the d20 mm space and add a magnet using a negative volume and a pause to embed it as well. See my model 1492069

for example.

I printed it in PETG and 0.15mm layer height, with ironing enabled. The 5 brush heads stand needs about 42g PETG and takes less than 4h to print.

A hole in each brush pin allows to insert a nail (d1.2 x 20mm) from below to enforce it (see attached image). You may redrill the hole to get the correct diameter before inserting the nail.

Please leave a comment and a make photo!

Figurines used on the title photo:
- 3D Benchy, scaled to 40% (https://www.3dbenchy.com/)
- Little ghost happy, scaled to 66%, glow in the dark (https://www.myminifactory.com/object/3d-print-halloween-ghosts-pumpkins-set-78940)
- Penguin, scaled to 49% (https://www.printables.com/model/40063-penguin-single-multi-material)
- Cute chicken, scaled to 40% (https://www.printables.com/model/956516-cute-chicken)
- Traffic cone, scaled to 4% (https://www.printables.com/model/1492069-pylon-traffic-cone-multicolor)