1 / 4
Canon EF-M to Minolta AF (Sony AF) With Aperture Control — image 1
1 / 4

Canon EF-M to Minolta AF (Sony AF) With Aperture Control

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A full featured adater to use Minolta AF Lenses with Canon EF mirrorless cameras (series M).

Rating
0 / 5
Likes
2
Downloads
12
Makes
0
Views
106
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

2026-01-08 UPDATE:

Minolta-Mount-M3 files were added for use with M3x10-20 countersunk screws (tested only with the Canon mount V2 due to limits of the Hex nuts being bigger than the inserts) instead of M2.5. This should provide greater strenght capabilities.

=========

The model requires some tight tolerances, since everyone has a different printer, filament ecc. the model is purposely made to require sanding in specific areas to make the tolerances exactly as you like.  This is a model for Minolta lenses with the aperture controlled mechanically by moving a small pin on the inside of the lens. Look at the last picture for a reference of what your lens should look like.

.STEP files are provided for easy remixing/editing

PRINT SETTINGS:

  • Material: PETG or ABS (PLA might work but it's prone to snap or deform under really hot conditions).

  • Layer height: 0.20 mm or lower.

  • Speed: as you like but keep it low.

  • Supports: Only needed in the canon-side mount.

  • Infill: 20-25% preferably gyroid due to the compression and torsion forces that needs to withstand.

 

PRINT INSTRUCTIONS:

  • Download the 3 Main components plus a hinge provided by the original creator. (https://www.printables.com/model/337699-sony-e-to-canon-ef-adapter-with-lens-lock) follow this link to know about the locking mechanism and the mounting instructions.

  • If you plan to use threaded inserts, please print the Canon mount V2 version, otherwise print the V1 keeping in mind it needs to be paused mid print to insert the M3 nuts.

  • Print the files in the following orientation.

  • Supports may be required in the Canon mount flanges.

MATERIALS NEEDED:

  • 4x M2.5 Screws

  • 4x M2.5 inserts or nuts (keep in mind this requires either V1 or V2 of the model)

  • Fine sand paper

  • Lubricant (if the aperture control ends up being too tight)

 

ASSEMBLY INSTRUCTIONS:

  • For Canon-Mount-V1:

    • In the G-Code, pause the print once the uppermost layer of the hex nuts has been reached like so:

    • Once the print pauses, carefully insert the nuts pressing them firmly all the way in.

    • Continue printing

  • For Canon-Mount-V2:

    • Print the part and use a soldering iron to press the inserts from the bottom.

  • Print the 3 Main components and mount them together as follows:

  • Screw the parts and try to move the aperture lever without forcing. It will likely move to much, in such case use the sand paper to scrape off some material in this section:

  • Continue the process of screwing tightly, trying to move, sanding, repeating until you get a snug fit (no visible light entering the adapter) but also a firm control on the aperture lever (I used a tiny amount of lubricant for keyboard switches since it's made to work with plastics and doesn't dry off).

  • Once you are satisfied with the result, try to mount the Minolta lens, if the fit is tight you are good, otherwise sanding on the Minolta-side may be required.

  • When you find the right tolerances, follow the instructions of the original creator for the locking mechanism: