Mountain and Clouds Decorative Pin Display

This is a display set for collectible pins that is made to look like a mountain surrounded by clouds. They are made to tilt slightly backward so as to allow the pins to be seen more easily when on a desk or table, and also to prevent them tipping forward.

The backing pieces are meant to be easy to put on and take off while keeping the pins from rattling around and bumping into each other. The pin post is meant to go into the middle hole of the backing piece, with small holes surrounding the center to account for the little tab that sticks out at the base of decorative pins. Note that these are optional as the normal pin backs work, but these ones I designed will hold the pins more firmly in place. For pins with multiple posts, you may find it easier to use only one of these custom backs and use the stock ones for the other posts for ease of placement and such.

For the feet - they should be fairly self-evident. I would recommend using a bit of glue to hold the feet on securely. For the full set, you'll need to print two of the mountain feet and four of the cloud feet.

This requires a larger bed than the Prusa bedslingers, so if you're using a Prusa printer, you'll probably need the XL or the Core One L.

Recommend printing with a small nozzle - like 0.2 or 0.25.