1 / 2
stronger quadlock receiver to 17mm ball (for joyroom phone mounts)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
remix of @rudra_550609 except this is printed as two pieces to glue together for a stronger part
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 34
- Makes
- 0
- Views
- 256
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
In addition, you'll need
- superglue
- small piece of styrofoam
- small hammer
- a small elevated flat surface no bigger than the underneath of the quadlock receiver (I used a glue stick for this)
print the top ball sideways so that the ball rod stem is along the printing lines.
After print, remove the supports for the base, put it on an object such that it is touching underneath the base, where the support was touching previously. In the hole where the rod goes, put a small piece of styrofoam and a few drops of superglue and mix. Hammer the rod in gently until you feel it has touched the base.
suggested settings:
- wall loops: 5
- support: type - tree auto, threshold angle - 2%
- support for “assembly - top.stl”: change threshold angle to 30%
- material: PETG basic
