1 / 2
Qidi Q2 Hotend Fan Bracket for 2510 & upgraded 3010 fan — image 1
1 / 2

Qidi Q2 Hotend Fan Bracket for 2510 & upgraded 3010 fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Lightweight hotend fan mounting bracket with a duct. Standard 2510 fan & upgrade 3010 fan sized both available.

Rating
3.667 / 5
Likes
45
Downloads
215
Makes
5
Views
1,848
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATES

This is a compact and lightweight hotend fan bracket for the Qidi Q2. The brackets have ducts on them to help guide the air where it needs to go. There is two version available, one is for the stock 2510 fan that comes on the printer and the other is for an upgraded 3010 fan. If you are interested in upgrading to a 3010 fan I recomend the Honey Badger 3010 from Fabreeko linked here https://www.fabreeko.com/products/3010-performance-axial-fan?_pos=1&_sid=16984af0c&_ss=r. Keep in mind the 3010 fan will not fit with a front cover on.

I will also put the instructions below for how to upgrade to the 3010 fan as you need to change some g-code in klipper.

PRINT SETTINGS

 

0.2mm Layer Height

Classic Walls 

4 Walls

25% Honeycomb infill

 

FILAMENTS

 

I personally printed mine Fiberon PET-CF17 and it has held up great so far. I would recommend ABS/ASA but you can try other materials at your own risk. 

 

MATERIALS

 2x Black stock hotend fan housing screws (Washers are not used)

The Honey Badger 3010 fan comes with a 3 pin and 2 pin connector, you want the 2 pin one for our case. There is three wires that come on the fan Red (24V), Black (Ground) and White (Tachometer/RPM). We won't be using the white wire so you can cut it, remove it or just tape it up so it's out of the way and there is no exposed wire. You want to make sure when putting your 2 pin connector on that when looking at the side of the connector that shows the metal pins, the Red (24V) wire is on the left and the Black (Ground) wire is on the right like in the picture below.

Our new 3010 fan now has a 2 pin connector unlike the stock fan which had a 4 pin connector. We will be using this blue Polar Cooler 2 pin on the toolhead board that is circled below.

Sense we are using a different connection on the toolhead board we need to change a little bit of code in our printer.cfg. Scroll down in your printer.cfg until you see the [heater_fan hotend_fan] section. There you will delete all of the contents and replace it with this, then save and restart. After that is done you are all good to go but if you need any help or have any questions please reach out.

[heater_fan hotend_fan]
pin:THR:PB10 #FAN2 pins
max_power: 1.0
shutdown_speed:0
cycle_time: 0.010
hardware_pwm: False
kick_start_time: 0.100
heater: extruder
heater_temp: 50.0
fan_speed: 1.0
off_below: 0