Flyable plane
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.88 – €1.08 net (excluding VAT)
For file: plane skeleton.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.98 excluding VAT (range midpoint).
- Weight reported by the author
- 5 g
- Print time reported by the author
- 1.34 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
the skeleton for a flyable plane. all you need to make it is serene wrap, some glue, and a clip
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 33
- Makes
- 0
- Views
- 303
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles & Machines
- License
- Creative Commons — Attribution
1. Cover the Main Wing
Apply a thin layer of glue to the top of the large front wing. Lay a piece of cling film over the glued surface and pull it tight so there are no loose areas.
2. Cover the Rear Wing
Apply glue to the bottom of the small rear (rudder) wing. Press the cling film onto it and trim off the excess with scissors.
3. Tighten the Film
Use a hair dryer, or hold the model several feet above a very low flame. The cling film will gently shrink and tighten. Do not overheat—just enough to firm it up.
4. Prepare the Nose
Wrap clear tape around the nose of the plane several times to make it slightly thicker. This gives the binder clip something to grip.
5. Add the Weight
Attach the small binder clip to the taped nose. This acts as the ballast and balances the glider.
Done
Your glider is ready to fly.