LumenPnP foot retainer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Securely attach rear LumenPnP feet to a table
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 45
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
I wanted to put my LumenPnP on this rolling desk that is only 23.5" inches deep. The soft pads of the feet just fit on the surface, but I wanted something to positively retain the PnP on the table in case it got bumped. The rear foot has a hole in it that I created a small retaining part for. The pin slides into the Lumen's foot, and then there are holes for #6 wood screws (not tested) or I used 0.5" 3M foam tape. This isn't the most secure thing in the world, but I'm just looking to keep a foot from getting bumped off when rolling it around or if it gets knocked into.
Note: I have a LumenPnP v3.1, but I believe the rear foot has not changed as of V4.1, but YMMV.
Printed using PLA, 0.2mm structural profile in Prusa Slicer. No supports needed when printed upside down.