Trash bag roll holder / dispenser + storage - up to 120mm diameter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A trash bag dispenser that can handle some pretty big rolls (+ a backup). Fits on standard Prusa bed without supports.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 68
- Makes
- 1
- Views
- 381
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried a few trash bag holder / dispenser designs and they were pretty good.
Ultimately I made this, combining the features I needed and avoiding the snags.
Handle a variety of brands, roll sizes - especially larger ones (we usually use 30gal Hefty)
Store an extra roll - we usually buy 2-packs and storage space is limited
Installs with screws, or most double-sided tape (up to 24mm wide) or Command Strips
Screw hole is ~6mm diameter, ~40mm deep
Minimize material use and print time. My Prusa Mk3S+ took <17hrs
I printed with:
No supports
0.3mm layers
3+ perimeters (so main cylinder walls are solid)
3+ top / bottom layers
Cubic infill (see screenshot - maybe 40%?)
PLA - since mine's installed inside and I wanted the extra rigidity compared to PETG.
So far it's holding up and working well, even with kids who hate taking out the trash.
TIP: if you install it with a slight tilt / rotation ~5+ degrees clockwise, the roll stays in place better when removing a bag.
I don't suggest printing GCODE directly, but I uploaded it in case the stats were helpful