100Hex Wall Frames (Filament Saver Remix)

Update: Included a version with rotated supports. I've also uploaded the OpenSCAD script if you want to customize the frame (check out this guide if you've never used OpenSCAD)

I recently discovered the 100Hex project by tecnoloxia_org and decided I would challenge myself to add a load of customizable hex designs (I've started uploading them here if you want to check them out).

Link

I liked the current frame design, but after printing one, I realised that I would end up using a load of filament just printing the frames. I also had trouble withthe snap-fit connector so decided to work on a quick solution.

Instead of printing an entire frame, just the main parts are included. You can print the hex with a base and change layers on height or just use card/paper to fill the back (which makes it easier to draw on/add color). I've used cheap recycled black card that I picked up on ebay, it's held in by the hex when it's fitted.

Rather than printing snap-fit connecters or a frame thick enough to fit a screw hole, there is holes for cotton string. You can simply tie the frames together and then use a bit of string to hang it on a nail or screw.

Thanks to the original creators! There is no way I would of had the idea for this without them.

According to cura:

This version:

• 11g
• Just over 1.5 hours

Original:

• 31g
• 3 Hours, 45 mins

and for each connector:

• 2g
• 16 mins

As per the original, you may find it better to scale this slightly. I find everything fits together perfectly if I print the frame at 100.1% width & length (or the hexes at 99.9%). It will depend on your printer and filament so print a test before you go wild!

The hexes in the images are:

• 100 Hex Single Lightbulb (edge) by minching
• 100hex portal by 2CoB9
• The torus is from the original 100Hex, I believe it was made by tecnoloxia_org