The Emergency Nappy (Diaper) Change Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Snap-open 3D-printed emergency nappy kit for those inevitable out-and-about nappy emergencies.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 42
- Makes
- 0
- Views
- 827
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
The Emergency Nappy Change Kit is a tiny, single-use, snap-open pack designed for those moments when you thought you were prepared… and life proves otherwise.
This print locks a full quick-change setup inside the part itself by pausing the print, inserting the supplies, and letting the printer seal it all in. When needed, you simply snap the kit cleanly in half along the built-in weak point to reveal everything you need for a nappy change.
They’re quick to print, fun to make, and incredibly handy — plus they make brilliant gifts for new parents or parents-to-be.
Watch the video here 👇
Contents
1 x Newborn size nappies (diapers)
3 x Individually packages wet wipes
1 x Doggy bag
A mint or individually packaged treat
Print Settings
This is very easy to print, and should be fine on any printer.
It prints on the small end, just add a print pause just before bridging starts on the top layers, and slide your nappy, with the other bits inside, into the part before resuming.
Recommended material: PLA or PETG (for heat and UV resistance, ASA if you're using in Summer)
Layer height: 0.34 mm
Infill: 12–15 % (Gyroid or Grid)
Perimeters: 2
Supports: Not required