BIQU MicroProbe V2.0 mount for Voron Stealthburner / Prusawire
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Uses the M2.5 nuts & bolts delivered with the probe, no probe modification necessary
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 46
- Makes
- 0
- Views
- 297
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
Description
Biqu microprobe V2 mount for X-carriage used in Prusawire / Stealthburner
Hardware needed
Biqu microprobe V2
2x heated insert M3 (4.6mm x 5.7mm)
2x M2.5 screws (short) and 2x M2.5 washers delivered with the microprobe V2
2x M3x10 or M3x12 flat heat or cylinder head screw
Printing
Prints without supports on the face with the holes for the heated inserts. Use a heat resistant material, such as ASA. Recommended: layer height is 0.1mm, 100% fill.
Installation
Set two M3 heated inserts into the holes of the mount
Slide the M2.5 nuts into the slots in the part
Attach the microprobe using the two short M2.5 screws while paying attention to the orientation. The cable connector of the probe must be located at the chamfered edge of the mount.
Attach the mount to the X-carriage parts by two M3x10 or M3x12 screws. (You will need to unmount the printhead from the carriage)
Double check the probe position. The circuit board and cable connector must be visible when the probe is attached.
Adjust the probe position so that the distance of the probe head to the printbed is 1-2mm shorter than your printhead distance.
Probe offset
X: -1.8mm | Y: 25.4mm