QIDI BOX PTFE Filament Saver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Prevents filament wear at the QIDI BOX inlet
- Rating
- 0 / 5
- Likes
- 35
- Downloads
- 180
- Makes
- 0
- Views
- 1,888
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The filament was being worn down by the metal part at the entrance of the QIDI BOX, so I used a PTFE tube to prevent it from being worn down.
Printing uses ABS.
1. Use pliers or wire cutters to remove the metal part from the main unit of the 1QIDI BOX.
2. Cut a piece of PTFE tubing approximately 70mm (2.75591 inches) long.
tpfe tube↓
https://www.amazon.co.jp/uxcell-PTFE%E3%83%81%E3%83%A5%E3%83%BC%E3%83%96-%E9%AB%98%E6%B8%A9%E3%83%81%E3%83%A5%E3%83%BC%E3%83%96%E3%83%91%E3%82%A4%E3%83%97-mm%E5%86%85%E5%BE%84x4mm%E5%A4%96%E5%BE%84x3-%E3%83%88%E3%83%A9%E3%83%B3%E3%82%B9%E3%83%9A%E3%82%A2%E3%83%AC%E3%83%B3%E3%83%88/dp/B09292K9YS/ref=sr_1_5?__mk_ja_JP=%E3%82%AB%E3%82%BF%E3%82%AB%E3%83%8A&sr=8-5
3. Insert it into the hole of the printed part and apply double-sided tape to the red area shown in the photo.
(Use tape that leaves no residue.)
I used this one↓
https://www.amazon.co.jp/%E3%82%A8%E3%82%B9%E3%82%A2%E3%82%A4%E3%82%A8%E3%82%B9-%E4%B8%A1%E9%9D%A2%E3%83%86%E3%83%BC%E3%83%97-%E5%B9%853cm%C3%971m%E5%B7%BB%C3%972mm%E5%8E%9A-%E8%B2%BC%E3%82%8A%E6%9B%BF%E3%81%88%E5%8F%AF%E8%83%BD-ISJL-0201-1/dp/B09R99VXV4/ref=sr_1_9?__mk_ja_JP=%E3%82%AB%E3%82%BF%E3%82%AB%E3%83%8A&sr=8-9
4 Attach it and push the PTFE tube all the way into the back of the QIDI BOX to complete the installation.
