Lakewood Desk Fan Knob
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A knob designed to fit the Lakewood HV-9 Desk fan. Not based on the original knob.
- Rating
- 5 / 5
- Likes
- 0
- Downloads
- 22
- Makes
- 0
- Views
- 103
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- GNU General Public License v3.0
The knob fell off my fan several years ago and I have no recollection of the original knob it had, So i was shooting in the dark.
The original must have been off-center based on the position of the actuator within the body and the part of the motor that juts out the back of the fan. I would have liked to make it bigger, but the knob is about as big as I could make it while keeping the "hole" centered.
This will likely fit several other fans, this specific 3-speed selector switch is fairly common.
It should just press-fit on.
I printed in PLA with 15% Gyroid infill, 0.1x0.3mm fuzzy skin on the knob body only (not the bore), and with a 5mm brim.