Jumbo Christmas Light Bulbs - Seamless - Fast (Under 60mins total) - Screw On - Tea Lights - Freestanding
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Convert boring tea lights into fun Christmas lights
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 38
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter & Christmas & New Year's
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Model 1: Light Bulb - Base - Threads
Single perimeter (minimal material, strong enough for screw mount)
Variable layer height (maintains thread consistency)
Estimated Print time: 30 mins
Model 2: Light Bulb - Bulb - Threads
Spiralized shell (seamless walls, no layer transitions)
Variable layer height (auto-optimizes for smooth curves)
Estimated Print time: 25 mins per bulb
About the Makes in Photos:
Base: eSun PLA Green (30 mins)
Bulbs: Elegoo Red PETG (25 mins), Elegoo Yellow PLA (25 mins), eSun Green PLA (25 mins)
Model 1: Base
Print Results
Specification | Value |
Estimated Print Time | 38m 19s |
Filament Used | 9.9 g |
Layer Height | 0.16 mm |
Wall Thickness | 1 perimeters |
Infill Density | 0% |
Supports Required | No |
Print Configuration
Setting | Value |
Adaptive Layer Height | Enabled |
Nozzle Diameter | 0.40 mm |
Filament & Temperature
Setting | Value |
Filament Type | 1.75 mm |
Nozzle Temperature | 222C |
Bed Temperature | 55C |
Print Notes
Optimized for Ender 3 V2 with BLTouch bed leveling
Uses off-print purge line to prevent nozzle blobs
Exported from PrusaSlicer
⚠ Adjust temperatures based on your filament type (this was printed with the temperatures listed above)
Recommended: Test on a small print first before large jobs
Adjust temperatures +/-5C if experiencing adhesion or stringing issues
Model 2: Bulbs
Print Results
Specification | Value |
Estimated Print Time | 25m 9s |
Filament Used | 10.1 g |
Layer Height | 0.28 mm |
Wall Thickness | 1 perimeters |
Infill Density | 0% |
Supports Required | No |
Print Configuration
Setting | Value |
Print Mode | Spiral Vase |
Adaptive Layer Height | Enabled |
Nozzle Diameter | 0.40 mm |
Filament & Temperature
Setting | Value |
Filament Type | 1.75 mm |
Nozzle Temperature | 222C |
Bed Temperature | 55C |
Print Notes
Optimized for Ender 3 V2 with BLTouch bed leveling
Uses off-print purge line to prevent nozzle blobs
Exported from PrusaSlicer
⚠ Adjust temperatures based on your filament type (this was printed with the temperatures listed above)
Recommended: Test on a small print first before large jobs
Adjust temperatures +/-5C if experiencing adhesion or stringing issues