ZYBER 8G STAND
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ZYBER 8G STAND
- Rating
- 5 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 108
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This stand is designed for the Zyber 8G bitcoin miner to improve airflow and cooling performance.
By lifting the miner higher off the ground, the stand allows clean air to enter from the bottom and exit through the front and rear, reducing heat build-up and improving temperature stability.
In testing, the miner dropped approximately 4–5°C simply by sitting on the stand — without a fan installed.
The design also supports upgrading to a 120 mm fan, replacing the smaller stock fan to provide higher airflow and more efficient cooling.
Split the model in your slicer:
For best strength and print reliability, split the main body from the legs in your slicer.
Supports required:
Make sure supports are enabled,
Orientation:
Print parts flat where possible for maximum strength and dimensional accuracy.