Omphobby M2 V3 Pro landing skid

For those who, like me, tend to crash their RC helicopter just when the spare parts are out of stock. I modelled a replacement landing gear for my favourite helicopter, thinking that I'm going to need a few more in the future. Besides, you may choose a different color than white.

I printed it in PLA and in PETG (on the picture), both are perfectly fine and strong enough - but I recommend PLA because it looks better. Printed with supports, 0.15 layer height, 50% infill, vertical shells set to 4 perimeters. For easiest assembly block supports in the mounting holes, otherwise you need to clean them with a 1.5 mm drill.

Update: Since this item is still sold out most of the time, I ended up printing more... Made small improvements: Slightly stronger legs, added small rib to better lead the canopy, opened up the canopy fixing bracket so it is easier to remove supports.

I also experimented with several settings for printing because I found that the legs on the left side came out ugly. So far the nicest result was 0,15 mm layer height, structural preset, with very slow (35mm, 50%) perimeter speeds. I added the file for Core One.