Flite Test FT Simple Cub Landing Gear.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printable landing gear for the FT Simple Cub with shock absorbing rubber bands
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 39
- Makes
- 0
- Views
- 211
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
This landing gear is printed in one piece with no supports (front face down on bed). It has the same rubber bands I use to hold the wing on as shock absorbtion and there is a living hinge designed into the print to allow it to flex where it connects to the plane.
1/8in or 3mm steel rod pieces are needed for reinforcement: 2x 100mm are hot glued into the channel on the leading edge to reinforce the legs. 2x ~30mm (depends on your wheel thickness) are used for axles. I heated these up with a lighter and melted them into place, but they could be glued in.
I reccomend printing in PETG for flexibility and impact resistance, PLA might be too brittle. Other filaments like Nylon or PC could be good as well.