Milwaukee Fastback 6-in-1 Tip-up knife clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mod for the Milwaukee Fastback 6-in-1 utility knife to relocate the clip to the opposite side.
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 113
- Makes
- 1
- Views
- 1,350
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
My one and only complaint about this knife is the location of the pocket clip. When I pull out the knife, I like it to be in the orientation that it fits into the hand for use.
This mod will swap the clip to the side that puts the blade in a tip-up position facing the outside seam of the right-hand pocket.
Some don't like tip-up because they're afraid the blade will open in the pocket. This mod isn't for everyone.
This is a very small and cheap mod. All you need is an M3x10 button head cap screw, an M3 washer, an M3 nut, and the printed parts. The print takes less than 10 minutes.
Assembly is simple. Press the M3 nut into the backer. Loosen the screw right next to lanyard loop with a T6 torx. Place the backer behind the lanyard loop and sandwich it into the knife halves. Tighten the torx screw.
Remove the clip with a #2 philips screwdriver. Place the clip mount over the backer that's installed in the lanyard. Install the clip with the M3x10 along with the M3 washer.