Kossel Mini RAMPS1.4 mount

A simple RAMPS1.4 holder for mounting the electronics below a Kossel Mini printbed. Suitable for Kossels with 15x15 extrusions.

Note: The bed has to be raised slightly by about 10mm, to have enough clearance for the large thermal fuses. Suitable bed holders can be found here:

What you need

Please note: All links to Amazon (amzn.to), AliExpress (s.click.aliexpress.com) or marked with * are affiliate links, through which I receive a small commission. Perhaps you would like to support my work by making a purchase.

Parts used (BOM)

• 1x RAMPS1.4 mount (printed)

• 4x M3x10mm allen head screws (estimated, length has to be verified)

• 4x M3 allen head screws for mounting RAMPS board

• 4x M3 washers

• 4x M3 nuts

Tools used

• Screwdriver or allen-key suitable for your M3-screws
  https://amzn.to/45a8DPQ

Suggested print settings

• Rafts: No

• Supports: No

• Resolution: 0.2mm layer thickness

Instructions

• Slice model and print mount.

• Place printed mount inside of your Kossel Mini base. The triangle shaped cutout will allow enough clearance around the stepper motor.

• Use 4x M3x10mm screws, washers and nuts to mount holder in the base of your Kossel Mini. Do not tighten nuts, yet.

• Insert RAMPS and check forenough clearance on all sides, especially around the USB port. You might want to check with a USB cable installed.

• Remove electronics and tighten screws.

• Insert RAMPS again and mount it with M3 screws. The screws will cut itself into the plastic.

• Connect controller board with cables.

• Install your print bed.

• Have fun with your cleaned up Kossel Mini. 😉