1 / 4
Printable Moon Clips for Rock Island Armory/Alfa Proj AL9.0 9mm Revolver — image 1
1 / 4

Printable Moon Clips for Rock Island Armory/Alfa Proj AL9.0 9mm Revolver

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Designed and tested in PA6-GF filament. Range-use version of the moon clips for an AL 9.0 9mm revolver. See Description

Rating
0 / 5
Likes
8
Downloads
45
Makes
0
Views
218
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

After purchasing a RIA/Alfa Proj. AL9.0 9mm revolver, I needed a way to easily reload without having to spend a fortune in moon clips. After checking the forums to see if folks had printed moon clips and finding minimal success in materials such as PLA, I was determine to make my own version that would fit properly, hold the rounds securely, and drop in and eject cleanly like the factory steel version. After multiple iterations, these do exactly that! 

Pay CLOSE ATTENTION to the build notes below. These NEED to be printed a certain way in order to work. Also worth noting, THESE ARE NOT MEANT FOR DUTY USE!! While they work just fine on the range, they will not resist bending or impacts like actual steel ones will. These are meant to be an affordable way to practice, ONLY. Details below, please leave me a comment if you have any questions!

  • Files included:

    • AL 9.0 Moon Clips 0.55 center thickness V3-this is the default version suitable for all standard brass cased cartridges

    • AL 9.0 Moon Clips - SMALLER BORES for SNAP CAPS V2-this version is designed to fit AZOOM snap caps, which have a smaller inner ring diameter where the snap cap holds onto. 

  • Print details:

    • Material-I printed mine in Bambu PA6-GF. This allows for enough impact resistance and toughness (PA) while having enough rigidity to function properly (GF). Using CF filaments may be too rigid. Using PETG will cause them to shatter. I've tested with PA6-GF, if you want good results I recommend sticking with that or experimenting at your own risk. 

    • Infill-100%

    • Walls-2, only one wall on the top layer

    • Top and Bottom Surfaces-3 each

    • Layer Heights-0.15mm ea

    • Top and Bottom Patterns-Monotonic (bottom) and Monotonic Line (top)

  • How to load:

    • These can be easily loaded by hand, however if you want a consistent way to load these I will attach to a moon clip loader tool which I modeled up one afternoon that works quite well and prints in only two pieces. 

    • Insert cartridges straight in to the moon clip, and remove by pulling straight out, do NOT pull the rounds downward or you will bend and possibly break the tabs. 

Tags