Custom shine through keycaps for ZSA Voyager
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stem: Choc V1, Spacing: MX. There are two files one is a normal 1u keycap and the other is a 1u homing keycap.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Disclaimer: This is not an easy print. Make sure you test print one or two before you print a whole batch.
These keycaps were made for printing with fuzzy skin point distance 0.2 and fuzzy skin thickness 0.24. Apply fuzzy skin on only the top surface, the outer side walls only. Don't apply on the homing dots nor the hole. The print will work without fuzzy skin but the homing dots might feel sharp.
My print settings:
0.4mm nozzle
0.12mm layer high quality
Normal(block) supports(default)
4 walls and 30% infill
Bambu lab A1
Bambu PLA basic black
Print in 45 degrees angle to get the best result(cosmetic).
These are not easy to print. More than 20% of your prints will fail if build plate is not properly cleaned. I recommend applying a small amount of glue to the of the build plate for better adhesion.
Just got my 3d printer less than a month ago so can't give out much advice. These keycaps look beautiful when printed correctly so good luck!