1 / 4
Wall Hanging Planter Crystal
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These hanging planters are pretty easy to print, and don't use a lot of material, with a wall thickness of just 1mm.
- Rating
- 5 / 5
- Likes
- 111
- Downloads
- 300
- Makes
- 1
- Views
- 1,851
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Rotate to orient the open side toward the buildplate in your slicer. Probably best to use a brim as well since the surface area on the bed is pretty small. To hang them, I just used a small piece of nylon twine and knotted the ends inside the holes. I printed in PETG and it ended up with a small amount of seepage which allows excess water to drain.