3D printer test low filament
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
has overhangs, clearance, stringing tests, and lots more.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 30
- Makes
- 0
- Views
- 113
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The first layer height should be .2 mm. The goal is to be able to read the word "precision" on the bottom. The overhang test should be possible to take out with little effort. None of the corners should lift, and the print should not have stringing. For the holes, the goal is to have them be as round as possible.
TROUBLESHOOTING:
Lifting corners/edges
use a higher build plate temp
use adhesives (Elmers glue stick etc.)
use a brim or raft
slow the first layer down
Low overhang tolerance
increase cooling fan speed
slow down on overhangs past a set threshold
Overhang test doesn't come out of model
the overhang test has a clearance to remove it
the clearance is .4mm and that is the usual standard for most 3d printers
if it is stuck try changing wall print order to outside first
First layer
if the first layer seems to be separated and stringy, increase extrusion on first layer
If the first layer doesn't let you remove the clearance test or you cannot easily read the word "precision" on the bottom, reduce extrusion precent
if you have any questions, leave them in the comments section and I will try to reply.