Cable clamp for an ADILS leg
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cable guiding solution for organising a 3G1.5 cable behind ADILS IKEA legs.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 35
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi folks,
My desk is far away from a power supply, so whenever my wife comes into the room, she always blames the same thing. The cable looks horrible. So, I designed a way to hold it in place behind the ALDIS IKEA leg. The cable is a 3G1.5 H05VV-F
The first version worked well, but it broke if you opened it multiple times. So, I modified it to have a hinge to prevent this issue from happening again. After a few tests, I found the correct tolerances to make the hinge work. I just printed it in place without supports. The only important thing is to let it cool down before moving the part; if the part is still hot, it will break apart.
I printed the V1 with PETG and the V2 with PLA; I achieved good results with both materials. It's important to keep the printer in good condition; otherwise, it will be difficult to make the hinge work with this level of tolerance. Last but not least I use 3x10 SPAX screws to hold the part tight to the feet.
V1:
V2:
Have a good printing!!