1 / 8
UniFi UA-G2-PRO UA-G3-PRO Faceplate 30 and 45 degrees Angle — image 1
1 / 8

UniFi UA-G2-PRO UA-G3-PRO Faceplate 30 and 45 degrees Angle

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ubiquity Unifi Door Access UA-G2-PRO UA-G3-PRO 30 and 45 degrees Angle

Rating
0 / 5
Likes
3
Downloads
69
Makes
0
Views
309
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Ubiquity Unifi Door Access UA-G2-PRO UA-G3-PRO 30 and 45 degrees Angle.

picture are of the 45 deegress was for the ver1.0 where the mounting holes are a bit off and Wall mounting was too big (used radius instead of diameter). should be fix in the v1.1

The faceplace is 1mm offset up, but the design has it right in the middle, if you want to to be right in the middle, if doing a left angle, bring all the mounting hole down by one mm, of 1mm up of doing right angle. Works fine as is though.

I did not click in the faceplate hence the gap in the picture.

FreeCad 1.0.2 design file included

Note:
Wall Mount screw location are the same as the previous design for UA-PRO so that it is easy to upgrade.

UA-Pro design here

https://www.thingiverse.com/thing:4966148
https://www.printables.com/model/241854-unifi-ua-pro-faceplate-45-left-angle
https://www.myminifactory.com/object/3d-print-unifi-ua-pro-faceplate-45-left-angle-185856

Tags