Pandoro

A "Pandoro" is an Italian traditional Christmas dessert, made from sweet bread, usually sprinkled with icing sugar and some people decorated it with little strawberries or cream.

As is something that last few moments in home, we decide to create a version non eatable to decorate our dining table.

The parts are stackable, so you don’t need a multi-material printer to print it. In addition, you can use it as a stackable toy.

The extra decorations can be attached with a drop of glue.

Print configuration (using pla):

The pieces are named by floor, from 1-6, meaning the 1 the lower floor and 6 the higher. If you want a smaller Pandoro, I recommend you to remove floors, starting from the nº 1.

You can use your favourite configuration to print the pieces, there is nothing special to take care, just try to config it to save material as is a big print and enable fuzzy skin to improve the appearance. 
If you want to use it as a toy, I would recommend an extra perimeter, top layer and bottom layer for the main pieces to improve strength.

Supports not needed.

My print settings:

General:
Recommended to print in a textured sheet plate.
Layer height 0.2mm.
Nozzle wide 0.4mm
One top and bottom perimeter enabled.
2 wall perimeters.
3 bottom layers.
4 top layers.

Cake layers:
Top infill pattern: Hilbert curve.
Fuzzy skin: Outside walls.
Fuzzy skin thickness 0.08mm.
Fuzzy skin point distance 0.2mm.
Infill: Two options, as the cake is big, you could opt for 10% gyroid if you want to use it as a stackable toy or use lightning to save material. The 6 pieces with 10% gyroid are 582g aprox , with lightning 343g instead.

Infill layers:
Top infill pattern: Monotonic lines.
Fuzzy skin: Outside walls.
Fuzzy skin thickness 0.08mm.
Fuzzy skin point distance 0.2mm.
Infill:  5-10% gyroid.

Top Cookie:
Top infill pattern: Monotonic lines.
Fuzzy skin: Outside walls.
Fuzzy skin thickness 0.08mm.
Fuzzy skin point distance 0.2mm.
Infill:  20% gyroid.
4 bottom layers.
5 top layers.

Buttermilk:
Layer height 0.1mm.
Top infill pattern: Monotonic lines.
Infill:  20% gyroid.
4 bottom layers.
5 top layers.
Fuzzy skin up to you. I have it enabled.

Berrys:
Layer height 0.1mm.
Top infill pattern: Monotonic lines.
Infill:  20% gyroid.
4 bottom layers.
5 top layers.
Fuzzy skin up to you. I have it disabled as it loses some detail.
Rotate the model in the desired final position and sink it 1.5-2mm to stablish a good base for printing.
If you have problems with adhesion, use a smooth plate.