A Better Bowden Tube Adapter for the Creality Space Pi Filament Dryer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Make printing from your dryer easier and faster!
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 174
- Makes
- 2
- Views
- 1,016
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Where's the problem?
I love my Creality Space Pi filament dryer but printing directly from it has been slightly problematic. The Bowden tube always seems to get pulled into the dryer and wrapped up in the roll, especially during long prints, simply because the rubber grommet doesn't do a great job of holding the PTFE tube securely in place. This oversight in design also makes it difficult and annoying to change out rolls of filament, primarily threading the new roll into the PTFE is tedious and annoying.
How did you fix this?
I designed this to be simple yet effective and most of all easy to print without doing any permanent modifications to the dryer itself. The design is comprised of 3 parts: the Top Nut, the Screw and the Lower Nut. The Lower Nut is installed in the inside of the enclosure and includes a nice little funnel to help guide the filament into the Bowden tube path. The screw is secured into the Lower Nut and passes through the existing hole in the enclosure. From there the Top Nut provides the PTFE tube securement, is threaded onto the Screw and secures the whole assembly in place with friction.

BOM:
1x E3D Bowden Tube Collet
Print Settings:
Recommended Material: PETG, ABS, ASA or PA
0.4mm Nozzle or smaller
0.1mm layer height (0.2mm will work but the threads aren't as nice)
1.2mm Shell thickness (3 walls and 12 layers top and bottom @ 0.1mm with a 0.4 nozzle)
20-30% infill
NO SUPPORTS
Parts are pre-orientated for optimal printing.
Assembly:
Insert Bowden Collet into the top of "Top Nut"
Remove rubber grommet from the top of the dryer unit
Thread "Screw" into "Lower Nut" till it seats - Do not overtighten ( Note the orientation pictured below )
Install the Lower Nut and Screw assembly into the hole you removed the grommet from with the funnel pointed towards the lid of the Space Pi
Thread the Top Nut onto the now exposed threads of the Screw Finger Tight!
Install PTFE Tube into the new collet connection making its fully seated down with the collet pulled up
Load your filament and start printing!
