1 / 11
M25x1.5 Blind Stuffing + Nut and TPU-Sealing / M25x1.5 Blindstopfen + Mutter und TPU-Dichtung — image 1
1 / 11

M25x1.5 Blind Stuffing + Nut and TPU-Sealing / M25x1.5 Blindstopfen + Mutter und TPU-Dichtung

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

M25 blind stuffing to close unused openings for M25/PG21 cable gland in housings (ca 25.0mm). Optional TPU-sealing.

Rating
5 / 5
Likes
15
Downloads
261
Makes
1
Views
414
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

M25x1.5 threaded blind stuffing to close unused M25-openings.
Unused PG21-openings in housings are also possible to close with this blind-stuffing set, but it is necessary to widen the opening in some cases (see details below).

[1] Thread type:
  Metric tread

[2] Diameters for suitable openings:
  Diameters for M25x1.5 opening:
  a) threaded hole:                    23.5mm / M25x1.5 thread
  b) drill hole without thread:  25.0mm / no thread
  Diameters for PG21 opening:
  a) threaded hole:                    26.8mm / PG thread 
  b) drill hole without thread:  >28.3mm / no thread
  c) For a PG21 opening you can also use 
      https://www.printables.com/model/1503307-pg21-blind-stuffing-nut-and-tpu-sealing-pg21-blind
      as alternative .     

[3] Sealing:
  An optional TPU-sealing model file is available.

Print
Material:   PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim:         not required
Serial printing (part by part) for better thread quality.

Assembly
Threaded opening:
Screw the blind stuffing into the M25x1.5 opening.
Optionally place sealing on stuffing before assembly.
Unthreaded opening:
Place blind stuffing in PG21/M25 opening and secure with M25x1.5 nut.
If necessary, widen the opening to >=25.0mm before assembly.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.

Hint: 
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)

Tags