1 / 2
PVC Pipe Sword Cross Guard
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Turn a PVC pipe into a legitimate dueling sword with cross guards
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 16
- Makes
- 0
- Views
- 81
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Disclaimer: Exercise caution and use only in outdoor or open spaces. Designer is not responsible for personal injury, property damage, or hurt feelings.
You will need the following extra hardware:
1x 0.75in ID PVC pipe (1-1/16in or 27mm OD)
4x socket screws: 10-32 x 1.5in or M5 x 40mm
4x hex nuts: 10-32 or M5
insulating foam jacket
Print the model version corresponding to the screws you have. PETG is recommended, since PLA sags over time and has poor impact resistance. If the screws get stuck in the holes, pre-drill them out with a 5mm bit.