1in Curtain Rod Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I created this supper simple curtain rod holders in order to cover the extra spaice under my stairs
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 62
- Makes
- 0
- Views
- 326
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printing 2 of these rod holders should fit on any rod 1in or smaller. Rods smaller than 1 inch will wiggle a little.
When ataching to the wall i mounted one first then treded the curtain on the rod while it was in the mount and then atached the other mount to the other side.
This can be printed without suports if you print with the part that holds the rod facing down. The overhang is small and will never be seen once the rod is incerted in.
I printed on my MK3s and used the draft setting(.3mm layer height) for amazon basics pla with 10%infill. This seemed to be supper strong.