1 / 11
Cable clamp for ClosetMaid uprights — image 1
1 / 11

Cable clamp for ClosetMaid uprights

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.33 – €0.41 net (excluding VAT)

For file: Cable clamp - Part 1_0.4n_0.2mm_PLA_MINIIS_27m.bgcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.37 excluding VAT (range midpoint).

Weight reported by the author
3 g
Print time reported by the author
27 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

This is a clip to dress wires up against the upright rails of your Rubbermaid ClosetMaid hardware.

Rating
4.5 / 5
Likes
6
Downloads
30
Makes
1
Views
86
Reviews
2

Updated at source:

Model information

License
Open Community License v1

The extension cord for our vacuum charging dock was always in the way, so I wanted to hold it tucked up against the wall.  I tried Chicodemilo's Cord Snuggler for ClosetMaid ShelfTrack but it was too large for a single lamp cord. So I designed this clamp to hold the cable tucked behind the upright rail. I wanted them to be stronger, so I printed with the hooks horizontal. If you have good layer bonding you could print them with no supports by orienting the model with the hooks up. 

Tags