1 / 1
Cartographer CNC carriage XY-endstop mounting block — image 1

Cartographer CNC carriage XY-endstop mounting block

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

single-piece mount for endstop switches

Rating
0 / 5
Likes
2
Downloads
8
Makes
0
Views
169
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I upgraded a Voron rev C cable chain to the rev D Nitehawk-SB umbilical with the intent to do sensorless X & Y homing.  Sensorless didn't work out, and I'd rather put the switches on the toolhead before putting anything back on the gantry rails.

I also have CNC gantry joints, so the original LDO-supplied XY module can't easily be repurposed.  This mount utilizes all 4 threaded M2 holes on the toolhead carriage for stability; the X switch should strike the side of the rail carriage, and the Y switch is aimed at the side of the B motor.

Disclaimer:  Use this part/configuration at your own risk.  Having any active parts extending from the toolhead (mainly the Y switch) puts those parts at risk of crashing into any other objects that might be at the rear of the printer (mainly the Z chain).  Removing the switch levers does not completely negate the risk.

BOM (for Nitehawk-SB toolhead connection)

  • heatshrink tubing

  • ~20cm 3-conductor wire

  • 2 - D2P microswitches (the -L switch is ok as the lever is removable)

  • 1 - JST-XH 4P female socket

  • 3 - JST-XH 2.54 pitch female pins

  • 4 - M2x10 SHCS

  • 2 - M2x10 self-tapping screws (mount X switch)

  • 2 - M2 nuts

  • 2 - M2 split (lock) washers

  • 2 - M2x16 SHCS (mount Y switch)

Printing:  No supports, ABS/ASA strongly recommended, and the usual Voron settings (4 perimeters/layers, 40% gyroid fill)

The toolhead board pinout can be found here:  https://docs.ldomotors.com/en/Toolboard/nitehawk-sb

  • 5v pin is not used

  • Cut & crimp, solder wire ends as appropriate

    • heatshrink at/on/over switch terminals strongly recommended

    • 1 wire each for X and Y "signal" and 1 for a common ground

  • Mount wired assembly to mounting block

    • do not overtighten screws as switch bodies can be easily damaged

Y switch can be oriented either end up as the B motor presents a large target surface.  IMPORTANT:  bend switch contacts downward to keep the cutout for the M5x8 BHCS extrusion mount clear

X switch should be oriented button-up (leverless) or lever-up to properly make contact with the target carriage block.

Mount the full assembly to the toolhead.  Take care when routing wires as there is no extra clearance between the mounting block and the CNC rail mounting bracket/screws.

Manually move the toolhead to homing positions to ensure switches are triggered properly.  Firmly secure switches and toolhead mount screws when completed.

Update your printer.cfg with the appropriate endstop pin settings, save & restart, then manually move the toolhead to the homing positions and ensure the switches are properly registering as triggered.

Tags