Floating Fish Hide

A floating dome for your fish to hide inside of. You have to scale it up to around 700x-1000x the original size. Be careful when printing and putting it into your tank because some printers have trouble with printing with curves on the bottom. What I'm trying to say is that the ring will come out stringy and weird on the bottom because it is not flat against the base plate. I printed it using the tree support mode and they came out relatively easily, so that would probably be your best option. In the future I may add more rings around the other holes so that someone's fish doesn't get stuck or to prevent fins from being cut.  Just make sure you sand down the areas that were connected to supports, because after removing them I found that it was rough, so just sand it down to prevent pieces of plastic from floating around in the water or to prevent your fish's/fishes' fins from being cut. It may not actually seem like it, but I am a native English speaker, I'm just in a rush to type all of this out :|.  FYI the model is large and will REALLY LAG YOUR COMPUTER WHEN DOWNLOADING IT and placing the file into the slicer, so just beware of that.