FRITZ!SmartControl 440 Desk Stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.03 – €0.04 net (excluding VAT)
For file: fritz-stand-440-magnet-hole-cover.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.04 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 36 sec
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A Stand for the FRITZ!Smart Control 440 control panel, which also serves as a temperature sensor for FRITZ! thermostats
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 27
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This stand for the FRITZ!SmartControl 440 allows you to place your sensor close to where you are, providing temperature readings and thus optimized room temperature control with FRITZ! thermostats. The stand uses the same 50° angle than Elgato Stream Decks. It also has two holes for 6x3 mm magnets (like these) to hold the device in place. The covers close the magnet hole and fix the magnet in place. The base can be left as is using supports or you can print the mat with the hexagonal pattern with TPU as a mat to avoid the model slipping on your desk.