Bearing wheel mount for MN82 Trailer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wheel mounts with 625 bearings for MN82 trailer
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 34
- Makes
- 0
- Views
- 621
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The original model relies on fat wheel shafts. In my case it was not spinning freely enough and would require reprinting or postprocessing work. I decided to replace them with 625 bearings.
Print the frame (bed or driveon variant) from this remix based on the trailer model you are building. Print two pieces of the wheel attachment from this remix. Print four pieces of the wheel shaft from this remix. Putting it together is quite simple, as seen on the attached picture. Tires and rims work from the original model without changes.
Additional hardware required:
4x M3 washer
4x M3 nut
4x M3x20 bolt
4x 625 bearing (can be harvested from old printer v-wheels)
Use nylock nuts or apply threadlocker to regular nuts. They might get loose and detach after a while.