Pegboard/Skådis spraycan holder with size brackets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Pegboard spraycan holder with size brackets
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 46
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Summary
This is a spray can holder with brackets to be used on a IKEA SKÅDIS pegboard. The holder has a 66 degree tilt and is stackable sideways (and of course vertically, depending on what bottle you are using).
The holder comes with a series of brackets that will accommodate different sizes. The rings are snapped on by four small hooks.
General Dimensions
This is pretty straight forward. It takes up two connections on the pegboard and uses the T-nut fasteners. The holder has a 66 degree tilt and is stackable sideways (and of course vertically, depending on what bottle you are using).
Print Configuration
This should be printed butt side down.
For the can holder, 15-30% infill is more than enough.
For the brackets, 15-30% infill is enough, but depending on the amount of violence you are planning to use on them i would recommend a bit more.
It is recommended to print brackets with print order outer-inner for walls, to make sure that plugs are not being to hard to handle on the holder hooks.
Organic tree supports are recommended for screw holes. Although, they are a bit high up so i would just recommend printing without supports and then drill out any junk.
Part has a large flat base and does not need a brim.
Mounting
This part uses the legendary “Skadis T-Nut” system originally made by @6d6178:
